2011 Polaris Ranger RZR ATV Service Manual, Page 275Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 275

FINAL DRIVE NOTE: Due to extremely close tolerances and minimal wear, the bearings must be inspected visually, and by feelWhile
housingApply Loctite 603TM Bearing Replacement Bearing Removal 1Remove outer snap ringSnap Ring Snap Ring Bearing NOTE: Use
care to not allow any of the Loctite compound to get in the bearing2From the back side of the bearing carrier, tap on the
outer bearing race with drift punch in the reliefs as shown8Wipe the housing clean of any excess compound and install the
snap ring Bearing Carrier Bushing Replacement Check bearing carrier bushings and pivot tubes for excessive wear or damageIf
replacement is required, slide pivot tubes out and remove bushings with drift punchInstall new bushings by pressing them
into the bearing carrierPivot Tube Control Arm Bushing Drive bearing out evenly by tapping on outer race onlyOnce bearing
is at bottom of casting, support casting on outer edges so bearing can be removedInspect the bearing carrier housing for