2011 Polaris Ranger RZR ATV Service Manual, Page 279Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 279

FINAL DRIVE 5Make sure the circlip is on the shaft and not left in the jointCirclip NOTE: Shiny areas in ball tracks and
their own characteristic wear patternsIntermixing the internal components could result in looseness, binding, andor premature
failure of the jointIMPORTANT: If the grease in the joint is obviously contaminated with water andor dirt, the joint should
be replacedThe grease provided in the replacement kit is specially formulated for wear resistance and durabilityDO NOT use
substitutes or mix with other lubricantsNOTE: The amount of grease that's provided is premeasured, so use all the grease
Boot Replacement Grease Requirement: Grease Only Service Kits PN 1350059 (20g)PN 1350046 (30g)PN 1350047 (50g) Outer CV Joint
Capacity: RZR80g RZRRZR90g Thoroughly clean the joint with an appropriate solvent and dry the joint to prevent any residual
solvent from being left in the joint upon reassemblyVisually inspect the joint by tilting the inner race to one side to expose