2011 Polaris Ranger RZR ATV Service Manual, Page 281Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 281

FINAL DRIVE Inner Plunging JointBoot Replacement 1Using side cutters, cut away and discard the boot clamps5Make sure the
with water andor dirt, the joint should be replaced Clean the grease from the face of the joint and place the drive shaft
in soft-jawed viseUsing soft-faced hammer, or brass drift, strike the inner race of the joint to drive the joint off the
drive shaftBe sure to tap evenly around the joint to avoid bindingBrass Drift Shown Thoroughly clean the joint with an appropriate
solvent and dry the joint to prevent any residual solvent from being left in the joint upon reassemblyVisually inspect the
joint for damageReplace if neededClean the splines on the end of the shaft and apply light coat of grease prior to reassembly