2011 Polaris Ranger RZR ATV Service Manual, Page 282Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 282

FINAL DRIVE 11Install NEW circlip on the end of the shaft12Grease the joint with the special joint grease provided in the
grease Boot Replacement Grease Requirement: Grease Only Service Kits PN 1350059 (20g)PN 1350046 (30g)PN 1350047 (50g) Inner
Plunging Joint Capacity: RZR80g RZRRZR90g 13Fully compress the joint and push the drive shaft firmly into the inner race14Align
the circlip with the lead-in chamfer Axle Boot Clamp Tool: PU-48951 or CV Boot Clamp Pliers: 8700226 20Pull out on the drive
shaft to center the joint in the housingSlide straight O-ring pick or small slotted screw driver between the large end of
the boot and the joint housing and lift up to equalize the air pressure in the boot21Position the boot lip in its grooveInstall
and tighten the large clamp using the appropriate clamp tool 15Use soft-faced hammer to tap the joint onto the drive shaft
until you reach the end of the splines and the joint locks in place16Pull on the joint to test that the circlip is seated