2011 Polaris Ranger RZR ATV Service Manual, Page 330Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 330

BRAKES BRAKE BLEEDINGFLUID CHANGE NOTE: When bleeding the brakes or replacing the fluid always start with the furthest caliper
bleeder screw securely and remove bleeder hoseTorque bleeder screw to 47 inlbs(5.3 Nm)Repeat procedure Stepsfor the remaining
calipers 10Add brake fluid to MAX level inside reservoir Master Cylinder Fluid Level Master Cylinder Remove Cover Between
the MIN and MAX line shown on the reservoir11Install master cylinder reservoir cover12Field test machine at low speed before
putting into serviceCheck for proper braking action and pedal reserveWith pedal firmly applied, pedal reserve should be no
less than 12"(1.3 cm)13Check brake system for fluid leaksIf changing fluid, remove old fluid from reservoir with Mity VacTM
pump or similar tool Mity VacTM (PN 2870975) 3Add brake fluid to the indicated MAX level of reservoir Polaris DOT Brake Fluid
(PN 2872189) 4Begin bleeding procedure with the caliper that is farthest from the master cylinderInstall box end wrench on