2011 Polaris Ranger RZR ATV Service Manual, Page 342Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 342

BRAKES Pad Inspection 12Clean the caliper with brake cleaner or alcoholMeasure the thickness of the pad materialReplace pads
install rubber dust boots56 Master Cylinder Fluid Up to MAX line inside reservoir 7Install wheel and torque wheel nuts to
specification 2Compress mounting bracket and make sure dust boots are fully seatedInstall pads with friction material facing
each otherWheel Nuts: Steel Wheels: 27 ftlbs(37 Nm) Aluminum Wheels: 30 ftlbs+ 90 (14 turn) Brake Burnishing Procedure WARN
G If brake pads are contaminated with grease, oil, or liquid soaked do not use the padsUse only new clean padsIt is required
that burnishing procedure be performed after installation of new brake pads to extend service life and reduce noiseStart
machine and slowly increase speed to 30 mphGradually apply brakes to stop machineAllow pads and disc to cool sufficiently
during the procedureDo not allow pads or disc to become hot or warping may resultRepeat this procedure 10 timesDo not make