2011 Polaris Ranger RZR ATV Service Manual, Page 361Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 361

ELECTRICAL 456Use the trouble code reference table in the EFI Chapter for description of each codeIf more than one code exists,
Power (Vdc) Ground High Beam Input Fuel Level Sensor International Models Only Turn Signal Input, LH Turn Signal Input, RH
PIN 11 Instrument Cluster Installation 1Spray soap and water mixture onto the outer surface area of the instrument clusterThis
will help the instrument cluster slide into the rubber mount more easily Instrument Cluster Removal NOTE: Do not allow alcohol
or petroleum products to come in contact with the instrument cluster lens1Disconnect the wire harness connector from the
back side of the instrument cluster2Be sure the rubber mount inside the dash is fully installed and that the indexing key
on the rubber mount is lined up with the keyway in the dashHold the dash securely and insert the instrument cluster into
the dashTwist the instrument cluster gently in clockwise motion to properly seat the instrument cluster into the rubber mountApply