2011 Polaris Ranger RZR ATV Service Manual, Page 363Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 363

ELECTRICAL 6Adjust the beam to desired positionRepeat the procedure to adjust the other headlight Headlamp Housing Removal
wire harness from the headlamp bulbBe sure to pull on the connector, not on the wiring Carefully remove the headlamp from
the front bumperTurn the bulb counterclockwise to remove it Headlamp Housing Installation 12Install the headlamp housing
back into the front bumperSecure the headlamp housing with the rubber O-rings (A) on both sides of the headlamp and install
the adjustment screw (B)Reconnect wire harness or re-insert bulb if previously removedAdjust headlights using the "Headlight
Adjustment" procedure in this section Insert new bulbReinstall the wire harness onto the headlamp assemblyRepeat steps 1-3