2011 Polaris Ranger RZR ATV Service Manual, Page 378Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 378

ELECTRICAL NOTE: Note the alignment marks on both ends of the starter motor casingThese marks must align during reassembly3Remove
reassembly Slide positive brush springs to the side, pull brushes out of their guides and remove brush plateSlide brush end
frame off end of starter NOTE: The electrical input post must stay with the field coil housing4Measure resistance between
ground brush and brush plateResistance should be 0.3 ohms or less Brush InspectionReplacement 1Measure resistance between
starter input terminal and insulated brushesThe reading should be 0.3 ohms or lessRemember to subtract meter lead resistance