2011 Polaris Ranger RZR ATV Service Manual, Page 379Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 379

ELECTRICAL Brush Replacement 1Remove terminal nut with lock washer, flat washer, large phenolic washer, the small phenolic
in growlerTurn growler on and position hacksaw blade or feeler gauge lengthwise 18" (.3 cm) above armature coil laminatesRotate
armature 360 If hacksaw blade is drawn to armature on any pole, the armature is shorted and must be replaced Armature Testing
1Remove armature from starter casingNote order of shims on drive end for reassembly Use care when handling starter housingDo
not drop or strike the housing as magnet damage is possibleIf magnets are damaged, starter must be replaced Starter ReassemblyInstallation
1Install brush plate to field magnet housing aligning index tab Inspect surface of commutatorReplace if excessively worn