2011 Polaris Ranger RZR ATV Service Manual, Page 380Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 380

ELECTRICAL 2345Install O-ring, two small phenolic spacers, large phenolic washer, flat washer, lock washer, and terminal
brush wire and pushed completely into slot on phenolic plateUsing Dielectric Grease (PN 2871329), lubricate brush end bushing
and install shimsAlign brush plate and install cover and screwsLightly grease pinion shaft and install pinion, spring stopper,
and snap ringA AGear Assembly BThrust Washer CBusing DRetaining Ring EThrust Washer FStopper GCover HSpring 110Completely
assemble starter motor and torque set bolts to 3552 inlbs(3.95.9 Nm)11Install the starter onto the engine caseHand tighten
each of the starter boltsTorque the bottom bolt first to ftlbs(12 Nm)Then torque the top bolt to the same specificationE
Set Bolt Torque: 35-52 inlbs(3.9-5.9 Nm) Screw the overrun clutch out to the engaged position on the pinion shaft assemblyUse
small piece of wire with the end bent in hook and pick the old spring out of its channelSlide it off the end of the shaftSlide