2011 Polaris Ranger RZR ATV Service Manual, Page 381Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 381

ELECTRICAL 2Remove the retaining ring, thrust washer, spring retainers and clutch return springScrew the overrun clutch off
battery voltage for maximum of secondsWith the solenoid energized, resistance should read about0.5 between terminals (A)
and (B)If resistance measurement is out of specification, replace the starter solenoid Energize Here B Starter Solenoid Operation
To energize the Starter Solenoid the following must occur: The brake must be applied to provide ground path via the Orange
wire The key switch must be turn to the "start" position to ed provide 12V power via the GreenWhite wire Once the pull-in