2011 Polaris Ranger RZR ATV Service Manual, Page 383Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 383

ELECTRICAL STARTING SYSTEM TESTING FLOW CHART Condition: Starter fails to turn over the engineWith the tester on the VDC
the solenoid energized, resistance should read about 0.5 10 between the two terminalsIf resistance measurement is out of
specification, replace the starter solenoid (see "Starter Solenoid Bench Test") No Clean the battery-to-solenoid cable ends
or replace the cable Reconnect the solenoidConnect the tester black lead to the battery positive and the red lead to the
solenoid end of the battery-to-solenoid wireTurn the ignition key to the "start" positionReading should be less than .1 D.CYes
Connect the black tester lead to solenoid end of battery-to-solenoid cableConnect red tester lead to solenoid end of solenoid-to-starter
cableTurn the ignition key to the "start" positionReading should be less than .1 D.CYes Connect the black tester lead to
the solenoid end of the solenoid-to-starter cableConnect the red tester lead to the starter end of the same cableTurn the
ignition key to the "start" positionThe reading should be less than .1 D.CYes Replace the starter solenoid Clean the solenoid-to-starter