2012 Sportsman 400/500 and EFI Tractor Service Manual 9923412, Page 223Get this manual

2012 Sportsman 400/500 and EFI Tractor Service Manual 9923412, Page 223

CLUTCHING 7Place the alignment tool in the sheaves of the driven clutch and hold firmly as you rotate it down between the
the shaft bearing Clutch Alignment Tool PA-49011 8As you rotate the tool down between the drive clutch sheaves, the tool
should touch the clutch shaft bearing while maintaining clearance of roughly .020" between the tool and stationary sheave
of the drive clutch 11After completing the clutch alignment procedure, the belt should ride in the drive clutch with an approximate
.020" gap between the belt and stationary sheave and larger gap between the belt and moveable sheave.020" Gap Stationary
Sheave Shaft Bearing 9If the alignment tool hits the stationary sheave before it reaches the shaft bearing, the driven clutch
will need to be spaced out to correct the alignment Remove the driven clutchAdd the required amount of alignment washers
to obtain the correct measurement with the alignment toolYou may need to add more than one alignment washer Alignment Washers