2012 Sportsman 400/500 and EFI Tractor Service Manual 9923412, Page 240Get this manual

2012 Sportsman 400/500 and EFI Tractor Service Manual 9923412, Page 240

CLUTCHING NOTE: Bushings are installed at the factory using LoctiteIn order to remove bushings it will be necessary to apply
Use Bushing Tool PA-473368Install nut (C) onto end of puller rod and hand tightenTurn puller barrel to increase tension on
sheave if neededUsing hand held propane torch, apply heat around outside of bushing until tiny smoke tailings appear9Turn
sheave counterclockwise on puller rod until it comes freeLift sheave off puller10Remove nut from puller rod and set aside
Piston Pin Puller (PN 2870386) 3Remove nut from puller rod and set aside Piston Pin Puller (PN 2870386) Main Puller Adaptor
(#8) (PN 5020632) 11Pull bushing removal tool and adapter from puller rodRemove bushing from tool and discardDrive Clutch
Bushing Installation 1Place main adapter (Item 8) on pullerPuller Tool (A,B) Side "A" toward sheave Nut (C) 4Install puller
adapter (Item 10 from kit PN 2871226) Bushing Main Adapter (8) Piston Pin Puller 99234122012 Sportsman 400500 and EFI Tractor