2012 Sportsman 400/500 and EFI Tractor Service Manual 9923412, Page 255Get this manual

2012 Sportsman 400/500 and EFI Tractor Service Manual 9923412, Page 255

CLUTCHING NOTE: Bushings are installed at the factory using Loctite 609In order to remove bushings it will be necessary to
face down on puller5Install new bushing on installation tool (Item 2) and install assembly into sheave6Install left hand
thread nut (C) onto puller rod and hand tighten against installation tool7Turn clutch sheave counterclockwise, making sure
bushing is drawn straight into boreContinue until bushing is seated6Install left hand nut (C) and spacer onto puller rod
and tighten by handTurn puller barrel for further tension if needed7Turn clutch sheave counterclockwise until bushing is
removed and sheave comes free8Remove nut (C) (left hand thread) from puller rod and set aside9Remove adapters from puller10Remove
bushing and removal tool from adaptersDiscard bushing8Remove nut (C) from puller rod and set aside9Remove installation tool