1999-2004 Suzuki King Quad LT-300 300F ATV Factory Service Manual, Page 7Get this manual

1999-2004 Suzuki King Quad LT-300 300F ATV Factory Service Manual, Page 7

GENERAL INFORMATION ! ACAUTION ! parts replacement is necessary, replace the parts with Suzuki Genuine Parts or their equivalentWhen
tighten the larger sizes firstAlways tighten the bolts and nuts from the inside working out, diagonally and to the specified
tightening torqueWhenever you remove oil seals, gaskets, packing, O-rings, self-locking nuts, locking washers, cotter pins,
circlips, and certain other parts as specified, be sure to replace them with new onesAlso, before installing these new parts,
be sure to remove any left over material from the mating surfacesNever reuse circlipWhen installing new circlip, take care
not to expand the end gap larger than required to slip the circlip over the shaftAfter installing circlip, always ensure
that it is completely seated in its groove and securely fittedUse torque wrench to tighten fasteners to the specified torqueWipe
off grease and oil if thread is smeared with themAfter reassembling, check parts for tightness and proper operation To protect