1999-2004 Suzuki King Quad LT-300 300F ATV Factory Service Manual, Page 141Get this manual

1999-2004 Suzuki King Quad LT-300 300F ATV Factory Service Manual, Page 141

SHAFT DRIVE AND DIFFERENTIAL (LT-F300F) TOOTH CONTACT After backlash adjustment is carried out, the tooth contact must be
loading the front driven bevel gearThis will provide contact pattern on the coated teeth of the front drive bevel gear Remove
the front drive bevel gear, and inspect the coated teeth of the front drive bevel gearThe contact patch should be as shown
at right: If the tooth contact pattern is correct, as shown ingo to the Final Assembly sUb-section on p4-30 to complete installation
G) Incorrect (contact at tooth top) Correct Incorrect (contact at tooth root) If the tooth contact pattern is incorrect,
as shown in G), thinner shim is needed between the front drive bevel gear housing and the front driven bevel gear housing
If the tooth contact pattern is incorrect, as shown inthicker shim is needed between the front drive bevel gear housing and