1999-2004 Suzuki King Quad LT-300 300F ATV Factory Service Manual, Page 225Get this manual

1999-2004 Suzuki King Quad LT-300 300F ATV Factory Service Manual, Page 225

659 CHASSIS Install the selection lever cable CD into the cable stopper CV on the frameThen, finger tighten the selection
to the cable, selection lever, or shift lever Align the selection lever cable eye rod hole and pin holes with the notch in
the center (4WO) position of the shift lever case bracketFasten the selection lever cable and shift lever, by putting pin
through the pin holes from the inside of the shift case lever bracket, and an Ering to the pinNOTE: Direction of the eye
rod is determined by the side, differential case side or crankcase side, it is installed onIA CAUTION I Be sure to install
the selection lever eye rod accurately and that the end face of the selection lever contacts the flange face of the bushing
of the selection lever cableNOTE: In handling the push-pull cable, use care not to bend itShown in the illustration is strictly