2002-2007 Suzuki 500 LTA Service Manual, Page 163Get this manual

2002-2007 Suzuki 500 LTA Service Manual, Page 163

DRIVE TRAIN TOOTH CONTACT After backlash adjustment and left side shim selection are carried out, the tooth contact must
directionThis will provide contact pattern on the coated teeth of ring gear Remove the differential ring gear and compare
the coated teeth to the examples shown inand If tooth contact is found to be correct (example ), go to the FINAL ASSEMBLY
sub-section on p.4-14 to complete installation If tooth contact is found to be incorrect (example and ), the shim must be
changed and the tooth contact should be rechecked until correctCorrect Incorrect (Contact at tooth root) Make sure to check
the backlash and shim thickness after the tooth contact has been adjusted, since it may have changedAdjust the tooth contact