2002-2009 Suzuki LT-F250 Ozark Service Manual, Page 96Get this manual

2002-2009 Suzuki LT-F250 Ozark Service Manual, Page 96

TOOTH CONTACT After backlash adjustment is carried out, the tooth contact must be checkedPay attention to the following
the tooth contact has been adjusted, since it may have changedAdjust the tooth contact and backlash until they are both within
specificationIf the correct tooth contact cannot be maintained when adjusting the backlash, replace the drive and driven
bevel gearsTooth contact Contact at tooth top Contact at tooth root Drive bevel gear shim adjustment Driven bevel gear shim
adjustment Increase shim thickness Increase shim thickness Decrease shim thickness Decrease shim thickness For drive bevel
gear ( Shim thickness 0.25+0.25=0.50 mm (0.0197 in) 0.25+0.30=0.55 mm (0.0217 in) Combined shim 0.30+0.30=0.60 mm (0.0236
in) 0.30+0.35=0.65 mm (0.0256 in) 0.35+0.35=0.70 mm (0.0276 in) 0.25+0.25+0.25=0.75 mm (0.0295 in) 0.25+0.25+0.30=0.80 mm
(0.0315 in) 0.25+0.25+0.35=0.85 mm (0.0335 in) 24935-19B00-025: 0.25 mm (0.0098 in) 24935-19B00-030: 0.30 mm (0.0118 in)
24935-19B00-035: 0.35 mm (0.0138 in) 24935-19B00-090 24935-19B00-095 24935-19B00-100 24935-19B00-105 24935-19B00-110 24935-19B00-115