2002-2009 Suzuki LT-F250 Ozark Service Manual, Page 240Get this manual

2002-2009 Suzuki LT-F250 Ozark Service Manual, Page 240

ELECTRICAL SYSTEM INSPECTION IGNITION COIL PRIMARY PEAK VOLTAGE Remove the fuel tank left side cover( 7-5) Remove the left
ignition coil primary wire09900-25008: Multi circuit tester set Peak volt adaptor When using the multi circuit tester and
peak volt adaptor, refer to the appropriate instruction manual Shift the transmission to the neutral position and turn the
ignition switch to the "ON" position Press the starter button and allow the engine to crank for few seconds, and then measure
the ignition coil primary peak voltage Repeat the above procedure few times and measure the highest ignition coil primary
peak voltageTester knob indication: Voltage) Ignition coil primary peak voltage: More than 120 V Ignition coil CDI unit Battery