2003-2005 Suzuki LT-A500F Service Manual, Page 163Get this manual

2003-2005 Suzuki LT-A500F Service Manual, Page 163

DRIVE TRAIN TOOTH CONTACT After backlash adjustment and left side shim selection are carried out, the tooth contact must
pattern on the coated teeth of ring gear Remove the differential ring gear and compare the coated teeth to the examples shown
inand If tooth contact is found to be correct (example ), go to the FINAL ASSEMBLY sub-section on p.4-14 to complete installation
If tooth contact is found to be incorrect (example and ), the shim must be changed and the tooth contact should be rechecked
until correctMake sure to check the backlash and shim thickness after the tooth contact has been adjusted, since it may have
changedAdjust the tooth contact and backlash until they are both within specificationIf the correct tooth contact cannot