2004-2009 Suzuki LT-Z250 Service Manual, Page 7Get this manual

2004-2009 Suzuki LT-Z250 Service Manual, Page 7

GENERAL INFORMATION "If parts replacement is necessary, replace the parts with Suzuki Genuine Parts or their equivalent When
and nuts, tighten the larger sizes firstAlways tighten the bolts and nuts diagonally from the inside toward outside and to
the specified tightening torque Whenever you remove oil seals, gaskets, packing, O-rings, locking washers, self-locking nuts,
cotter pins, circlips and certain other parts as specified, be sure to replace them with new onesAlso, before installing
these new parts, be sure to remove any left over material from the mating surfaces Never reuse circlipWhen installing new
circlip, take care not to expand the end gap larger than required to slip the circlip over the shaftAfter installing circlip,
always ensure that it is completely seated in its groove and securely fitted Use torque wrench to tighten fasteners to the
specified torqueWipe off grease and oil if thread is smeared with them After reassembling, check parts for tightness and