2004-2009 Suzuki LT-Z250 Service Manual, Page 95Get this manual

2004-2009 Suzuki LT-Z250 Service Manual, Page 95

TOOTH CONTACT After backlash adjustment is carried out, the tooth contact must be checkedPay attention to the following
REASSEMBLY section on page 3-59 to complete installation1 Incorrect (contact at tooth top) Correct Incorrect (contact at
tooth root) If tooth contact is found to be incorrect (examples and 3), the shim thickness between the drive bevel gear and
driven bevel gear must be changed and the tooth contact rechecked until correct' Make sure to check the backlash after the
tooth contact has been adjusted, since it may have changedAdjust the tooth contact and backlash until they are both within
specificationIf the correct tooth contact cannot be maintained when adjusting the backlash, replace the drive and driven