2004-2009 Suzuki LT-Z250 Service Manual, Page 135Get this manual

2004-2009 Suzuki LT-Z250 Service Manual, Page 135

DRIVE TRAIN TOOTH CONTACT After backlash adjustment and left shim selection are carried out, the tooth contact must be checkedPay
2), go to the FINAL ASSEMBLY sub-section on page 4-13 to -15 to complete installationIf tooth contact is found to be incorrect
(examples and 3), the shim between the pinion gear bearing and gear case must be changed and the tooth contact re-checked
until correctTooth contact Contact at tooth top Contact at tooth rootMake sure to check the backlash and shim thickness after
the tooth contact has been adjusted, since it may have changedAdjust the tooth contact and backlash until they are both within
specificationIf the correct tooth contact cannot be maintained when adjusting the backlash, replace the pinion gear and ring
gear as setShim adjustment Decrease shim thickness Increase shim thickness Incorrect (Contact at tooth top) Correct Incorrect