2006-2009 Suzuki LT-R450 Service Manual, Page 3Get this manual

2006-2009 Suzuki LT-R450 Service Manual, Page 3

GENERAL INFORMATION [CAUTION I If parts replacement is necessary, replace the parts with Suzuki Genuine Parts or their equiva-
the inside toward outside and to the specified tightening torque Whenever you remove oil seals, gaskets, packing, O-rings,
locking washers, self-locking nuts, cotter pins, circlips and certain other parts as specified, be sure to replace them with
new onesAlso, before installing these new parts, be sure to remove any left over material from the mating surfaces Never
reuse circlipWhen installing new circlip, take care not to expand the end gap larger than required to slip the circlip over
the shaftAfter installing circlip, always ensure that it is completely seated in its groove and securely fitted Use torque
wrench to tighten fasteners to the specified torqueWipe off grease and oil if thread is smeared with them After reassembling,
check parts for tightness and proper operation To protect the environment, do not unlawfully dispose of used motor oil, engine