2006-2009 Suzuki LT-R450 Service Manual, Page 336Get this manual

2006-2009 Suzuki LT-R450 Service Manual, Page 336

CHASSIS Place the drive chain link being disjointed on the holder part of the toolso Turn in both the adjuster bolt and pressure
joint pins, O-rings and plates have been removed from the drive chain, the removed joint pins, O-rings and plates should
be discarded and new joint plate, O-rings and plate must be installed of the other side of jOint plate DRIVE CHAIN CONNECTING
JOINT PLATE INSTALLATION Set up the special tool as shown in the illustrationCD Tool body Adjuster bolt C2 Grip handle (without
hole) Joint plate holder Pressure bolt "A" (engraved mark "C520") (f) Bar Wedge holderwedge pin Connect both ends of the
drive chain with the joint pin inserted from the inside as installed on the motorcycle O-ring pcsJoint plate Joint set part