2006-2009 Suzuki LT-R450 Service Manual, Page 361Get this manual

2006-2009 Suzuki LT-R450 Service Manual, Page 361

ELECTRICAL SYSTEM CKP SENSOR PEAK VOLTAGE Disconnect the CKP sensor coupler Connect the multi-circuit tester with the peak
Peak volt adaptor Tester knob indication: Voltage (=-=-=) CKP sensor peak voltage: 0.5 and more Generator NOTE: After checking
the CKP sensor peak voltage, clear the OTC using SOS toolIf the peak voltage is within the specification, check the continuity
between the CKP sensor coupler and ECM coupler I CAUTION Normally, use the needle pOinted probe to the backside of the lead
wire coupler to prevent the terminal bend and terminal alignment CKP SENSOR RESISTANCE Disconnect the CKP sensor coupler
Measure the resistance between the lead wires using the multi-circuit testerIf the resistance is not within the specified