2008-2009 Suzuki 750 King Quad Service Manual, Page 43Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 43

0B-16 Maintenance and Lubrication: 3) Remove the left inner fenderRefer to "Front Side Exterior Parts Removal and Installation
the 6), 7) procedures until no air bleeds from the thermostat connector inlet8) Close the radiator cap securely9) After warming
up and cooling down the engine, add the specified engine coolant until the level is between the upper and lower lines on
the engine coolant reservoir tankI831G1020030-01 6) Flush the radiator with fresh water if necessary7) Tighten the drain
plug (4) to the specified torque CAUTION Replace the gasket with new oneTightening torque Engine coolant drain plug (a):
13 Nm (1.3 kgfm, 9.5 lbf-ft) I831G1020032-01 10) Reinstall the removed partsRadiator Inspection(a) Inspect radiator Every
000 km (600 miles, months) I831G1020031-02 8) Pour the specified engine coolant up to the radiator inletEngine coolant capacity