2008-2009 Suzuki 750 King Quad Service Manual, Page 265Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 265

1H-3 Ignition System: Step Action Yes Inspect the spark plugRefer to "Spark Plug Inspection and Go to Step 5Cleaning in Section
cylinder head with fingers, and then tighten them to the specified torque! The hot engine can burn youWait until the engine
is cool enough to touch1) Turn the ignition switch OFF2) Remove the right side cover and right inner fenderRefer to "Front
Side Exterior Parts Removal and Installation in Section 9D (Page 9D-6)"3) Disconnect the spark plug cap (1)4) Remove the
spark plug with spark plug wrenchSpecial tool0993010121 (Spark plug wrench set) CAUTION Do not cross thread or over tighten
the spark plug, or such an operation will damage the aluminum threads of the cylinder headSpecial tool0993010121 (Spark plug
wrench set) Tightening torque Spark plug: 11 Nm (1.1 kgf-m, 8.0 lb-ft) Spark Plug Inspection and Cleaning Refer to "Spark
Plug Inspection and Cleaning in Section 0B (Page 0B-9)" B831G21806002 Ignition Coil and Plug Cap Inspection Refer to "Electrical
Components Location in Section 0A (Page 0A-7)" B831G21806003 I831G1180001-01 Ignition Coil Primary Peak Voltage 1) Remove