2008-2009 Suzuki 750 King Quad Service Manual, Page 328Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 328

2C-3 Rear Suspension: 1Rear suspension arm pivot nut (upper) 2Rear suspension arm pivot nut (lower) 3Rear wheel hub nut 4WasherThe
to the thread part: Do not reuse Rear Shock Absorber Removal and Installation Removal 1) Place the vehicle on level ground
and support the vehicle with jack2) Remove the rear wheel assemblyRefer to "FrontRear Wheel Removal and Installation in Section
2D (Page 2D-2)"3) Remove the rear drive shaft cover (1) B931G22306003 Installation Install the rear shock absorber in the
reverse order of removalPay attention to the following points: Apply thread lock to the rear shock absorber mounting bolts:
Thread lock cement 9900032030 (THREAD LOCK CEMENT SUPER 1303 or equivalent) Tighten the rear shock absorber upperlower mounting
bolts and nutsTightening torque Rear shock absorber mounting nut (a): 60 Nm6.0 kgf-m, 43.5 lbf-ft) I831G1230004-01 4) Remove