2008-2009 Suzuki 750 King Quad Service Manual, Page 380Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 380

3B-24 Differential: Installation Installation the final gear assembly in the reverse order of removalPay attention to the
bolts and tighten the rear final gear case mounting nuts (1) and bolts (2) to the specified torqueTightening torque Final
gear case mounting nut (a): 65 Nm (6.5 kgfm, 47.0 lb-ft) Final gear case mounting bolt (b): 65 Nm (6.5 kgf-m, 47.0 lb-ft)Thread
lock cement 9900032030 (THREAD LOCK CEMENT SUPER 1303 or equivalent) I831G1320092-01 2) Remove the final gear cover bolts
I831G1320093-01 I831G1320090-06 3) Remove the final gear cover (2) from the final gear case, by using two mm screws Install
the rear drive shaft (left and right)Refer to "Rear Drive Shaft Assembly Removal and Installation in Section 3A (Page 3A-6)"
Install the suspension upper armsRefer to "Front Suspension UpperLower Arm Removal and Installation in Section 2B (Page 2B-9)"
Install the trailer towingRefer to "Trailer Towing Removal and Instruction in Section 9E (Page 9E-7)" Adjust the rear brake