2008-2009 Suzuki 750 King Quad Service Manual, Page 387Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 387

Differential: Final Drive Gear Inspect the final drive gear for wear or damageInspect the final drive gear bearing for abnormal
gearIf the backlash is not within specification, the shim must be changed and the backlash should be re-checked until the
backlash is within specificationCheck to the table for the appropriate shim thicknessNOTE Adjust the backlash by referring
to the table at using the thickness of the removed shims as guideBacklash Under 0.02 mm (0.0008 in) 0.02 0.06 mm (0.0008
0.0024 in) Over 0.06 mm (0.0024 in) Shim adjustment Increase shim thickness Correct Decrease shim thickness I831G1320131-01
Final Gear Shim Inspection and Selection Refer to "Final Gear Assembly Removal and Installation (Page 3B-23)"Backlash Install
the shim(s), final drive gear assembly and new final drive gear bearing stopper Tighten the final drive gear bearing stopper
(1) to the specified torque with the special toolNOTE As this time, it is not necessary to bend the bearing stopper collarSpecial