2008-2009 Suzuki 750 King Quad Service Manual, Page 406Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 406

3C-14 Transfer: Installation Install the gear position switch in the reverse order of removalPay attention to the following
I831G1330046-01 Tighten the gear position switch bolts (1) I831G1330048-01 4) Remove the generator coverRefer to "Generator
Removal and Installation in Section 1J (Page 1J-4)"5) Remove the gearshift shaft assembly (2) and washers (3) I831G1330047-03
Route the gear position switch lead wireRefer to "Wiring Harness Routing Diagram in Section 9A (Page 9A-4)" Install the V-belt
inner coverRefer to "Clutch Shoe Removal and Installation in Section 5A (Page 5A-16)" Install the drive V-beltRefer to "V-belt
Type Continuously Variable Automatic Transmission Removal and Installation in Section 5A (Page 5A-5)" Install the removed