2008-2009 Suzuki 750 King Quad Service Manual, Page 419Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 419

Propeller Shafts: Assembly Assemble the rear output shaft in the reverse order of disassemblyPay attention to the following
I831G1340035-02 Apply grease to the oil seal (3): Grease 9900025160 (Water resistance grease) Install the oil seal to the
rear output shaft yoke (4)! Install the rear output shaft driven bevel gear (7) and bearing (8)NOTE The wider side "a" of
the bearing should be positioned bevel gear side CAUTION Replace the oil seal (3) with new one I831G1340033-02 With the rear
output shaft held immovable with vise, tighten the rear output shaft driven gear nut (9) to the specified torqueI831G1340101-02
Apply thread lock to the thread part of the output shaft: Thread lock cement 9900032030 (THREAD LOCK CEMENT SUPER 1303 or