2008-2009 Suzuki 750 King Quad Service Manual, Page 421Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 421

Propeller Shafts: Rear Output Shaft Drive Bevel Gear Shim Inspection and Adjustment Place the rear output shaft on the left
(Dial gauge (1100 mm, 10 mm)) (E): 0990020701 (Magnetic stand) I831G1340043-04 I831G1340040-01 Install the C-ring (1) and
rear output shaft (2)NOTE Be sure to fit the bearing knock-pin "A" on the bearing to the groove of the crankcase Measure
the backlash by turning the drive bevel gear shaft in each direction, reading the total backlash with the dial gaugeIf the
backlash is not within specification, the shim must be changed and backlash should be re-checked until correctCheck the table
at the appropriate shim thicknessNOTE Adjust the backlash by referring to the table at the using the thickness of the removed
shims as guideRear output shaft bevel gear backlash Standard: 0.03 0.15 mm (0.0001 0.006 in) Backlash Shim adjustment Under
0.03 mm Increase shim thickness (0.001 in) 0.03 0.15 mm Correct (0.001 0.006 in) Over 0.15 mm Decrease shim thickness (0.006