2008-2009 Suzuki 750 King Quad Service Manual, Page 429Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 429

Propeller Shafts: 12) Unlock the nut with chisel13) Shift into the reverse gear14) Remove the rear output shaft yoke (10)3)
nut (3) with center punchI831G1340069-02 15) Remove the oil seal1 2 I831G1340072-02 7) Apply grease to the bearings and dust
seal lipI831G1340070-01 Installation! : Grease 9900025010 (SUZUKI SUPER GREASE or equivalent) CAUTION The removed oil seal,
nut, circlips and O-ring must be replaced with new ones1) Install the oil seal into the final gear case with the special
toolSpecial tool0991370210 (Bearing installer set) 2) Apply grease to lip of the oil seal: Grease 9900025160 (Water resistance