2008-2009 Suzuki 750 King Quad Service Manual, Page 451Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 451

Brake Control System and Diagnosis: Rear Brake Pedal Removal and Installation Apply grease to the pivot part of brake pedal:
specified torque: Thread lock cement 9900032050 (THREAD LOCK CEMENT 1342 or equivalent) Tightening torque Rear brake pedal
pivot nut (a): 11 Nm (1.1 kgf-m, 8.0 lb-ft) I831G1410039-02 5) Remove the nut (4), washer (5) and bolt (6) I831G1410042-02
I831G1410040-02 6) Remove the rear brake pedalInstallation Install the rear brake pedal in the reverse order of removalPay
attention to the following points: Apply grease to the O-rings as shown in the rear brake pedal constructionRefer to "Rear
Brake Pedal Construction (Page 4A-13)" After installed rear brake cable, adjust the adjuster nutRefer to "Rear Brake PedalRear