2008-2009 Suzuki 750 King Quad Service Manual, Page 520Get this manual

2008-2009 Suzuki 750 King Quad Service Manual, Page 520

SteeringHandlebar: Installation Install the tie-rod in the reverse order of removalPay attention to the following points:
32.5 lb-ft) Refer to "Steering Shaft Removal and Installation (Page 6B-6)" and "Tie-rodTie-rod End Removal and Installation
(Page 6B-9)" B831G26206007 Steering Shaft Holder Dust Seal Inspect the dust seal for wear or damageIf any defects are found,
replace the dust seal with new one I831G1620040-03 I831G1620042-01 Install the washers and tighten the rod end nuts (2) (steering
arm plate side) to the specified torqueTightening torque Tie-rod end nut (a): 29 Nm (2.9 kgf-m, 21.0 lb-ft) Install the cotter
pins (3)! Tie-rod Inspect the tie-rod for distortion or damageIf any defects are found, replace the tie-rod with new one
CAUTION The removed cotter pins must be replaced with new onesI831G1620043-01 I831G1620041-01 Install the tie-rod ends (steering