2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 12Get this manual

2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 12

00-5 Precautions: 3) Using test male terminal, check the female terminals of the circuit being checked for contact tensionCheck
"B": Check contact tension by inserting and removing"C": Check each terminal for bend and proper alignment 4) Using continuity
inspect or voltage check procedure as described below, inspect the wire harness terminals for open circuit and poor connectionLocate
abnormality, if any Voltage check If voltage is supplied to the circuit being checked, voltage check can be used as circuit
check1) With all connectorscouplers connected and voltage applied to the circuit being checked, measure voltage between each
terminal and body ground2) If measurements were taken as shown in the figure and results were listed in the following, it
means that the circuit is open between terminals "A" and "B"Voltage between "A" and body ground: Approx5 "B" and body ground:
Approx5 "C" and body ground: V I649G1000028-02 "D": Looseness of crimping "E": Open "F": Thin wire (A few strands left) Continuity