2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 195Get this manual

2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 195

Ignition System: Ignition Coil Removal and Installation Remove 1) Remove the fuel tankRefer to "Fuel Tank Removal and Installation
sensor 4Peak voltage adaptor Refer to "Electrical Components Location in Section 0A (Page 0A-6)"CKP Sensor Peak Voltage 1)
Remove the left side cover and left footrest mudguardRefer to "Exterior Parts Removal and Installation in Section 9D (Page
9D-3)"2) Disconnect the CKP sensor coupler (1)NOTE Be sure that all of the couplers are connected properly and the battery
is fully-charged 4) Measure the CKP sensor peak voltage in the following procedures: a) Shift the transfer to the neutral,
turn the ignition switch ONb) Press the starter button and allow the engine to crank for few seconds, and then measure the
CKP sensor peak voltage5) Repeat the procedure b) few times and measure the highest CKP sensor peak voltageCKP sensor peak