2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 205Get this manual

2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 205

Starting System: 4) Connect the neutral switch diode5) Install the left inner fenderRefer to "Exterior Parts Removal and
to "Handlebars Removal and Installation in Section 6B (Page 6B-3)"Special tool0990025008 (Multi-circuit tester set) Tester
knob indication Continuity) Color Position ON OFF I831G1190022-01 IgnitionStarter Control Relay Inspection Inspect the ignitionstarter
Control relay in the following procedures: 1) Remove the ignitionstarter control relayRefer to "IgnitionStarter Control Relay
Removal and Installation (Page 1I-8)"2) Check the insulation between "A" and "B" terminals using the multi-circuit tester3)
Apply 12 to terminals "C" and "D" ((+) to "C" and) to "D") and check the continuity between "A" and "B"If there is no continuity,
replace the ignition starter control relay with new oneSpecial tool0990025008 (Multi-circuit tester set) Tester knob indication
Continuity test) B827H21906011 4) After finishing the parking brake switch inspection, reinstall the removed parts Gear Position