2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 305Get this manual

2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 305

Differential: Breather Rubber Case Inspect the breather rubber case (1) for wear or damageIf any defects are found, replace
the table and using the thickness of the removed shims as guideBacklash Under 0.02 mm (0.0008 in) 0.02 0.06 mm (0.0008 0.0024
in) Over 0.06 mm (0.0024 in) Shim adjustment Increase shim thickness Correct Decrease shim thickness Refer to "Final Gear
Assembly Removal and Installation (Page 3B-21)" and "Final Gear Assembly Disassembly and Assembly (Page 3B-23)"Backlash 1)
Install the shim(-s), final drive gear assembly and new final drive gear bearing lock-nut2) Tighten the final drive gear
bearing lock-nut to the specified torque with the special toolNOTE As this time, it is not necessary to bend the bearing
stopper collar B827H23206017 Special tool (A): 0992441830 (Bearing retainer wrench) Tightening torque Final drive gear bearing
lock-nut (a): 80 Nm (8.0 kgf-m, 58.0 lb-ft) List of shims (for left side) Part NoShim thickness 27445-24A01-030 0.30 mm (0.0118
in) 27445-24A01-035 0.35 mm (0.0138 in) 27445-24A01-040 0.40 mm (0.0157 in) 27445-24A01-050 0.50 mm (0.0197 in) 27445-24A01-060