2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 324Get this manual

2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 324

3C-13 Transfer: Transfer Gearshift Cam Disassembly and Assembly (LT-A400F) Refer to "Transfer Removal and Installation (LT-A400F)
snap ringsRefer to "Gearshift System Construction (LT-A400F) (Page 3C-12)"! I831G1330039-01 1Snap ring "A": Thrust "B": Sharp
edge Install the gearshift cam (1) to the shaft! CAUTION Align the punch mark "A" of the gearshift cam with the punch mark
"B" of the shaft CAUTION Never reuse the circlip and snap ringAfter circlip and the snap ring have been removed from the
shaft, they should be discarded and new ones must be installed When installing new circlip and snap ring, do not expand the
end gap larger than required to slip the ring over the shaft After installing circlip and snap ring, make sure that they
are completely seated in their groove and securely fitted I827H1330031-01 Transfer Gearshift Shaft No.1 Bearing Inspection