2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 325Get this manual

2008 Suzuki LT-A400/F, LT-F400/F ATV Service Manual, Page 325

Transfer: Transfer Gearshift Cam Disassembly and Assembly (LT-F400F) Refer to "Transfer Removal and Installation (LT-F400F)
location and position of washers and snap ringsThe cross sectional view shows the correct position of the cam, washers and
snap ringsRefer to "Gearshift System Construction (LTA400F) (Page 3C-12)"! I831G1330039-01 1Snap ring "A": Thrust "B": Sharp
edge Install the gearshift cam (1) to the shaft! CAUTION Align the punch mark "A" of the gearshift cam with the punch mark
"B" of the shaft CAUTION Never reuse the snap ringsAfter snap rings has been removed from the shaft, it should be discarded
and new snap ring must be installed When installing new snap ring, do not expand the end gap larger than required to slip
the snap ring over the shaft After installing circlip and snap ring, make sure that they are completely seated in their groove