1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 132Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 132

IGNITION OUTPUT TESTSCD II i plugs installed and torqued in the cylinder headIf neces"" All cranking output tests must be
mm) from any metal surface i or spark tester during cranking tests "" To avoid possible shock hazard, do not handle ignition
coils 3If equipped, install the emergency stop switch clip and lanyard assemblyCrank the engineSpark should jump each tester
gap alternately If tester shows good output on both cylinders, go to STEPRUNNING OUTPUT TEST If tester shows good output
on one cylinder, go to STEPPOWER PACK OUTPUT TEST If tester shows no output, go to STEPSTOP CIRCUIT TESTIt is possible for
the ignition system to have problem but still produce good outputIf the engine "pops" or "backfires" during starting, the