1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 147Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 147

Thermomelt Stik Procedure 1Install correct test propeller and place engine in test tank i pellers, twist and remove all spark
increased to 5000 RPM, the 1630 (73 C) mark should remain dull and chalky If the mark becomes liquid and glossy, troubleshoot
the cooling system for causes of overheating Removal of Upper Crankcase Seal9.915 The presence of oil under the flywheel
could indicate leaking upper crankcase sealThe upper crankcase seal can be replaced without disassembly of crankcaseRemove
the flywheel as described in Section 3Use OMC Seal Remover, PIN 391060, to remove and install the seal rv Thread removerinstallertipbody
with tip into seal to To remove seal, install "C" into removerinstaller bodyengage metal case rv and remove sealWhile holding
removerinstaller body, turn pressing screw To install new seal, apply OMC Gasket Sealing Compound to the outside diameter