1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 157Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 157

Cleaning Before inspecting or assembling powerhead, all internal components must be perfectly clean and free of contaminants1Remove
using OMC Gel Seal and Gasket Remover L!J traces of gaskets, adhesives, and 4Use OMC Gel Seal and Gasket Remover to remove
all OMC Gel-Seal I from the cylinder block and crankcase 5Carefully remove any carbon accumulation from the tops and ring
grooves of the pistonA ring groove cleaning tool can be made by breaking an old ring and grinding an angle on its endDo not
damage ring grooves while cleaning6Thoroughly wash entire cylinder block and crankcase with warm, soapy water to remove all
traces of contaminants i compressed air pressure at less than 25 PSI (172 kPa) '" To avoid personal injury, wear eye protection