1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 160Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 160

1 Assembly r:=J Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must
Grease to the 22 needle bearings and install the bearings into the connecting rod[';14Slide the connecting rod with the needle
bearings and washer up and off the wrist pin, being careful notto disturb the bearingsPlace the connecting rod and the two
wrist pin washers in position in the piston cavity, aligned with the wrist pin bossI,l 5Finish installing the wrist pin through
the connecting rod and the piston until the wrist pin contacts the installed retaining ringCheck to be sure none of the needle
bearings have been disturbed and pushed out of the connecting rodInstall second new retaining ring Is' 3Slide one of the